Close
Existing Users Log In
   
Bits for Guitar Rosette Inlay

Bits for Guitar Rosette Inlay

Rated 5.00 out of 5 based on 1 customer rating
(1 customer review)

$12.99

These hard to find bits are ideal for inlaying guitar rosettes into the top. These bits can be used to install rosettes in both classical guitar and steel string guitars. Sizes available are 1/16″, 3/32″ an 1/8″.

Clear

Product Description

These hard to find end mill bits for guitar rosette inlay are ideal for installing rosettes one section at a time as demonstrated in both the Classical Guitar Making book and 10-DVD box set by John Bogdanovich. These bits allow you to build your rosette a section at a time, making the job easier. These bits can be used on steel string guitar rosettes as well.

These bits can be used with the 2-Pi Cutter Router Attachment. A variable speed router is recommended such as the Rigid R2400 variable speed laminate trimming router. The ability to reduce the speed will extend the life of the bits.

Bits come in three sizes 1/16″, 3/32″ and 1/8″, shank is 1/4″.

1 review

  1. Rated 5 out of 5

    billmccauley (verified owner)

    These quality tools are ideal, and I might say essential, for creating the rosettes shown in the book. Without them getting through the creation of the rosette would be difficult, with them it is a matter of careful planning and following instruction in the book.

    Very timely delivery.

Add a review

Additional Information

Weight .125 lbs
Dimensions 2 x .5 x .5 in
Sizes

1/16", 1/8", 3/32"